***EDUCATION REQUIRED - HIGH SCHOOL DIPLOMA OR GED***
SCHEDULE: DAY SHIFT - 5:00AM START TIME, STOP TIME RANGES FROM 1:30PM, 3:30PM, 5:30PM BASED ON WORKLOAD
SHIFT DIFFERENTIAL OF $2PH WILL BE APPLIED IF THEY MOVE TO THE NIGHT SHIFT.
TOP REQUIRED SKILLS:
- ABLE TO LAYOUT FULL SCALE DRAWING OF PIPING SYSTEM
- ABLE TO MEASURE, CUT, BEND, AND FIT-UP PIPING
- ABLE TO READ AND INTERPRET HYDRAULIC SCHEMATICS
JOB SUMMARY: Fabricate, Bend, Install, Assemble, Repair, and Maintain Piping Hydraulic systems.
PRIMARY RESPONSIBILITIES:
- Pull, push, or pry steel components into approximate position while member is supported by hoisting device.
- Force components in to final position, using crowbars, jacks and hand tools.
- Verify vertical and horizontal alignment of components using cutting torch.
- Cut steel components to make alterations using cutting torch.
- May repair products by dismantling, straightening, reshaping, and reassembling parts using cutting torch and tools.
- Lay out, fabricate, assemble and install piping and piping systems.
- Plan and coordinate daily work with limited supervision.
- Perform other work related tasks as assigned.
- Comply with all Company and HSE policies and procedures.
FACILITY/GROUP SPECIFIC RESPONSIBILITIES:
- Ability to follow leads direction with little supervision.
- Plan layout and installation in accordance with instruction or work requirement schematics.
- Work at elevated heights
- Operate man lift, scissor lift, and overhead crane.
- Understand common practices for instrument fitter.
- Work in fast pace, always changing environment.
- Shall be able to measure, cut, bend and fit-up various sizes of stainless-steel piping 1", 1-1/2", and 2"
- Shall be able to layout full scale drawing of piping systems.
- Shall be able to read and interpret assembly and hydraulic drawings.
- Shall be able to maintain and operate hydraulic tabletop bender.
- Shall be able to layout pipe runs and pipe support brackets in accordance with procedures.
- Shall be able to layout, position, align, and secure sub-assemblies using a level, straight edges, combination squares, plum bobs, and measuring tape.
JOB REQUIREMENTS:
- Will be standing, sitting and walking throughout the workday.
- Work in a non-climate control environment.
EDUCATION & EXPERIENCE QUALIFICATIONS:
- High School Diploma or GED.
- 3 or more years related experience.
- Read and interpret assemble/hydraulic drawings.
BEHAVIORAL COMPETENCIES:
- Informing.
- Learning on the fly.
- Technical Learning.
- Time Management.
Job Type: Full-time
Pay: $34.00 - $38.00 per hour
Expected hours: No less than 40 per week
Benefits:
- Dental insurance
- Health insurance
- Vision insurance
Schedule:
- 8 hour shift
- Monday to Friday
- Weekends as needed
Experience:
- pipefitting: 3 years (Preferred)
Ability to Commute:
- Houston, TX 77041 (Required)
Work Location: In person
